Yacy for Raspberry PI – notes

TLDR: Setup an Yacy Raspbian Image for your PI, presetup with minimal configuration needed. Yacy is an distributed search engine.

Maybe my memory notes are of use to someone else too.

Allow from outside to port 80, 8091,8092

Allow every port from internal subnet

To                         Action      From
—                         ——      —-
8091                       ALLOW       Anywhere
Anywhere                   ALLOW       192.168.1.0/24
80                         ALLOW       Anywhere
8092                       ALLOW       Anywhere
8091                       ALLOW       Anywhere (v6)
80                         ALLOW       Anywhere (v6)
8092                       ALLOW       Anywhere (v6)

as suggested at https://www.raspberrypi.org/forums/viewtopic.php?f=26&t=47115

  • The ports used in Yacy are 8091 for http, 8092 for https.
  • Enable SSH-server and any pub-keys and authorized hosts for easy login.
  • Turn off/on any features like ssh with raspi-config.
  • Change the default PI-user password.
  • Change the password for default Yacy-admin.
  • JVM for Yacy is set as max 856 mb mem – this should surely be more if your pie has it.
  • Takes a while to start, be patient.
  • Logs for yacy are under ~/yacy/DATA/LOG
  • Backup and compress the SD-image.https://raspberrypi.stackexchange.com/questions/311/how-do-i-backup-my-raspberry-pi#313

 

 

 

 

 

 

 

 

 

Tor on my Raspberry PI

The other week i got my cute little RaspberryPI.  Amongst the different projects i tried (it’s very nice to just have a set of SD-cards ready for this), i wanted a silent, small,low power Tor-relay.

Yey, I already had a Tor-relay, on an old Atompowered Asus EEE, with a broken flatscreen and a non-working keyboard. Works, but starting to reach it’s end-of-life. I read somewhere that the Raspberry PI can handle about 6 MBytes/Sec and that’s more than enough for me.

Well, the setup was really,really easy, here’s how to do it:

* Follow this guide for the basic Tor-install

Now, if you want a gui/monitor for Tor, there’s 2 ways to go. If you’re planning to run X, install Vidalia. Otherwise (or if you want something more lightweight) go for Tor-arm. My recomendation is that you install them both.

Installing arm

sudo apt-get install tor-arm

and that’s about it. Run it after you have started the Tor-process. You may need to have set the password for connectiong to Tor before this (/etc/tor/torrc)

screenshot_page1

Installing Vidalia

do

sudo apt-get install vidalia

  • you might have to change some folder permissions, check the vidalia message log from the vidaliaGUI, it’ll tell you.
  • Also, don’t forget to change the pathway to the config file in vidalia, so that it uses the same config as your original TOR install. ( /etc/tor/torrc).

And don’t forget to open the ports ORPort and DirPort (default 9001, 9030) in your firewall. And maybe do some portforwarding to your Raspberry in your router.

I’m very happy with my litte silent, low power-consumption,cheap Tor-relay. Working for freedom 24/7. After about one day i have the 50-80% cpu usage, and average of 2.1 MB/S down 2.5 MB/s up. No X started.

IMAG0517

Next, i’ll try to setup another one with I2P on it.